德國P+F編碼器AVS58N-011K1R0GN-0013原裝現貨低價銷售
ASM58全系列
 

參數表節選：的技術參數 AHM58-0
General specifications
Detection type photoelectric sampling
Device type Multiturn absolute encoder
Electrical specifications
Operating voltage 4.5 ... 30 V DC
No-load supply current max. 180 mA
Time delay before availability < 250 ms
Linearity ± 2 LSB at 16 Bit, ± 1 LSB at 13 Bit, ± 0,5 LSB at 12 Bit
Output code Gray code, binary code
Code course (counting direction) cw descending (clockwise rotation, code course descending)
Interface

德國P+F編碼器AVS58N-011K1R0GN-0013原裝現貨低價銷售
ASM58全系列

Interface type SSI
Monoflop time 20 ± 10 µs
Resolution 
 Single turn up to 16 Bit
 Multiturn 14 Bit
 Overall resolution up to 30 Bit
Transfer rate 0.1 ... 2 MBit/s
Voltage drop UB - 2.5 V
Standard conformity RS 422
Input 1
Input type Selection of counting direction (cw/ccw)
Signal voltage 
 High 4.5 ... 30 V
 Low 0 ... 2 V
Input current < 6 mA
Switch-on delay < 10 ms
Input 2
ASM58全系列

Input type zero-set (PRESET 1)
Signal voltage 
 High 4.5 ... 30 V
 Low 0 ... 2 V
Input current < 6 mA
Switch-on delay < 10 ms
Connection
Connector type 9416 (M23), 12-pin, type 9416L (M23), 12-pin
Cable ∅7 mm, 6 x 2 x 0.14 mm2, 1 m
Standard conformity
Degree of protection DIN EN 60529, IP65
Climatic testing DIN EN 60068-2-3, no moisture condensation
Emitted interference EN 61000-6-4:2007
Noise immunity EN 61000-6-2:2005
Shock resistance DIN EN 60068-2-27, 100 g, 6 ms
Vibration resistance DIN EN 60068-2-6, 20 g, 10 ... 2000 Hz
Approvals and certificates
UL approval cULus Listed, General Purpose, Class 2 Power Source
Ambient conditions
Operating temperature -40 ... 85 °C (-40 ... 185 °F)
Storage temperature -40 ... 85 °C (-40 ... 185 °F)
Mechanical specifications
Material

ASM58全系列

 Combination 1 Housing: aluminum Flange: aluminum Shaft: stainless steel
Mass approx. 300 g (combination 1)
Rotational speed max. 3000 min -1
Moment of inertia 30 gcm2
Starting torque < 3 Ncm
Shaft load 
 Angle offset ± 0.9 °
 Axial offset static: ± 0.3 mm, dynamic: ± 0.1 mm
 Radial offset static: ± 0.5 mm, dynamic: ± 0.2 mm