If using a CC type cylinder gauge for blind hole bore diameter, its guide plate interrupt the
 measurement at a point deeper than "T", as shown in the figure below.
 In such case, the CG type with modified guide plate is suitable for measurement of the
 diameter to the point as deep as "t".
Dial gauge is not furnished and supplied only on request.
  Suitable dial gauges are 17Z, 57B (0.01mm) and 15Z, 5F (0.001mm)

Specifications
Model		Range (mm)	Effective measuring range (mm)	Wide range accuracy (?m)	Adjacent error (?m)	Repeated accuracy (?m)	Number of anvils (mm)	Thickness of spacers (mm)	Extension collar (mm)
CG-01		10 - 18	0.5	5	2	2	Intervals 1mm×9	0.5mm
CG-1		18 - 35	1.2	5	2	2	Intervals 2mm×9	0.5, 1mm each
CG-2		35 - 60	1.2	5	2	2	Intervals 5mm×6	0.5, 1, 2, 3mm each
CG-3		50 - 100	1.2	5	2	2	Intervals 5mm×11	0.5, 1, 2, 3mm each
CG-3C		50 - 150	1.2	5	2	2	Intervals 5mm×11	0.5, 1, 2, 3mm each	50mm×1
CG-4		100 - 160	1.2	5	2	2	Intervals 10mm×7	1, 2, 3, 4mm each
CG-5		160 - 250	1.2	5	2	2	Intervals 10mm×10	1, 2, 3, 4mm each
CG-6		250 - 400	1.2	5	2	2	Intervals 10mm×16	1, 2, 3, 4mm each
List of special length below grip (available on request)

Dimensions (mm)
Model	A	B	C	D	E	F	G	H	I
CG-1	246	150	3	70	23	20	10	18 - 35	13
CG-2	246	150	3	70	23	20	10	35 - 60	18
CG-3	246	150	3	70	23	20	10	50 - 100	20
CG-3C	246	150	3	70	23	20	10	50 - 150	20
CG-4	380.5	251.5	3	100	26	25	16	100 - 160	50
CG-5	380.5	251.5	3	100	26	25	16	160 - 250	70
CG-6	533	400	4.5	100	26	25	16	250 - 400	100
Dimensions (mm) CG-01 Dimensions for Spacers for Cylinder Gauges Model T (mm) A (mm) B (mm) CG-1 0.5, 1 4.1 5 CG-2 0.5, 1, 2, 3 4.1 6 CG-3 0.5, 1, 2, 3 4.1 6 CG-3C 0.5, 1, 2, 3 4.1 6 CG-4 1, 2, 3, 4 4.1 6 CG-5 1, 2, 3, 4 4.1 6 CG-6 1, 2, 3, 4 6.1 8.8