The given measuring ranges are also available in kg/cm2, MPa and kPa.
    Vacuum and +/- measuring ranges are also available.
    Vacuum resistance
    Yes

    Output signals

    Accuracy

   Accuracy at reference conditions
      ≤ ±2 % of span

    Including non-linearity, hysteresis, zero offset and end value deviation （corresponds to measured error per IEC 61298-2）.
    Calibrated in vertical mounting position with process connection facing downwards.

   Non-linearity
      ≤ 0.5 （BFSL per IEC 61298-2）

   Temperature error
      ≤ ±2.0 % of span

   Long-term drift （per IEC 61298-2）
      ≤ 0.3 % of span/year

    Settling time
      ≤ 2 ms

   Voltage supply
    The permissible power supply depends on the corresponding output signal.

    Total current consumption maximum 10 mA （except for 2-wire signals）

   Operating conditions
  

    Ingress protection （per IEC 60529）
      IP 67

    The stated ingress protection only applies when plugged in using a mating connector that has the appropriate ingress protection.

   Vibration resistance
    20 g （20 ... 2,000 Hz, 2 h） per IEC 60068-2-6 （vibration under resonance）

   Shock resistance
    40 g （6 ms） per IEC 60068-2-27 （mechanical shock）

   Temperatures

   Reference conditions （per IEC 61298-1）

   Temperature
      15 ... 25 °C

    Atmospheric pressure
      860 … 1,060 mbar （665 ... 800 mmHg）

    Humidity
      45 ... 75 % relative, non-condensing

    Power supply
      DC 24 V
      DC 5 V with ratiometric output

    Mounting position
      as required

    Process connections

   Electrical connections
      Short-circuit resistance
      S+ vs. 0V

   Reverse polarity protection
      UB vs. 0V

    Insulation voltage
      DC 500 V

    Connection diagrams

   Cleanliness specifications


    Packaging
    For the individual levels of cleanliness of the model MG-1 the following types of packaging are available.

    Materials

    Wetted parts
      Process connection from stainless steel 316L and 13-8 PH
      Sealing ring from FKM （if available）

   Non-wetted parts
      Case from stainless steel 316L
      Electrical connection from highly resistant, glass-fibre reinforced plastic PBT GF 30

    Approvals, directives and certificates
 

    CE conformity
      EMC directive 2004/108/EC, EN 61326 emission （group 1, class B） and immunity （industrial application）
      Pressure equipment directive 97/23/EC

    Dimensions in mm
    Pressure transmitter

    Process connections

Ordering information
Model / Measuring range / Output signal / Electrical connection / Process connection / Level of cleanliness / Type of packaging

咨詢定購WIKA 氧用壓力變送器 MG-1WITH M121 connector 壓力變送器